![]() Use a pre-wetting technique or vacuum equipped with high efficiency (HEPA) filter(s) instead. Prevent any uncontrolled release of the product. Avoid generating or releasing vapour, mist, dust or gas into the workplace air.Keep containers tightly closed when not in use.Open containers slowly and carefully to prevent spills and dispersal into the air. Inspect containers for damage or leaks before handling.Always work with the smallest amount possible.Follow the safe work practices specified on the SDS and by your employer.If it is not possible to eliminate the use of an Acute toxicity product, evaluate whether it is possible to use a substitute, such as a less hazardous product (e.g., products that are classified for Acute toxicity - Category 3 or 4 are less hazardous than those classified for Acute toxicity - Category 1 or 2).ALWAYS Check the SDS for information about ALL of the hazards and the necessary precautions for the product being used.How can products with the skull and crossbones pictogram be handled safely? Back to top physical hazards such as corrosive to metals, flammability or reactivity.ĪLWAYS check the Safety Data Sheet (SDS) and label for the product that you are working with to make sure that you know what is being used and all of the hazards associated with the product.other health hazards such as skin corrosion or irritation, carcinogenicity, and/or specific target organ toxicity (single or repeated).In addition to the specific hazards identified by the skull and crossbones pictogram, it is important to remember that the product may have other hazards, for example: Acute toxicity (Inhalation) – Category 3 is “In contact with water, releases gases which are toxic if inhaled.”Īre there other hazards associated with products with the skull and crossbones pictogram? Back to top.Acute toxicity (Inhalation) – Category 1 or 2 is “In contact with water, releases gases which are fatal if inhaled.”.In this situation, the required statement for a gas that is: The WHMIS 2015 signal words and hazard statements for the hazard classes and categories assigned the skull and crossbones pictogram are: Hazard Class and CategoryĪcute toxicity (Oral) – Category 1 and Category 2Īcute toxicity (Dermal) – Category 1 and Category 2Īcute toxicity (Inhalation) – Category 1 and Category 2Ī supplementary hazard statement is required if the product, upon contact with water, releases a gas that can cause acute toxicity. What signal words and hazard statements are used? Back to top ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |